![]() ![]() Ultra Clear Deep Pour Epoxy has a “softer” overall finish compared to table top epoxy and is susceptible to scratching and denting if left as a stand-alone final coat. These polymers should be used only by adults or under adult supervision.Mixed resin and hardener, if left in a mixing container for more than ten minutes, may begin to heat up, shortening working time.Allow product to cure for 12 hours before adding additional one inch thick layers. Note: For a project greater than one inch thick, multiple pours may be needed.Use the torch to burst additional bubbles as needed for up to 40 minutes after the initial pour.For stubborn or deep-set bubbles, heat the tip of a narrow screwdriver and pop the deep bubbles with the hot tip of the screwdriver.Allow it to dry prior to subsequent applications over one inch thick. Once any bubbles are eliminated, repeat the pouring process with additional 1/4 inch layering until either satisfied or you've reached a maximum of one inch layer thickness.Pop the bubbles as you go by waving a propane torch back and forth, four to six inches above the surface.After thoroughly mixing, slowly pour the Ultra Clear Deep Pour Epoxy over the surface you wish to coat, gradually filling your layer in approximately 1/4” thick.Propane torch or heat gun: Used for bubble release.Gloves or notched spreader or squeegee: May be needed for certain product applications.Brush: Sometimes a small brush is needed for coating edges of crevices.Stick: Must have flat, straight edge to ensure thorough mixing.>.Mixing container: Should have smooth flat bottom and be clean and dust free.Measure two parts resin component to one part hardener component in a clean container. Caution: Inaccurate measuring will cause epoxy surface to remain soft or sticky “spots” on the epoxy surface.Unused resin and hardener should be left in their original storage containers and used within 60 days to avoid undesirable yellowing inside the bottles. ![]() ![]() Carefully scrape the sides and bottom of the pail during mixing. Thoroughly mix the epoxy with a stir stick.Do not exceed 1.5 gallons combined in a single batch. Measure two parts Resin A to one part Hardener B by volume.Mix only the amount of Ultra Clear Deep Pour Epoxy that you need at one time.It is a good idea to put a newspaper or a drop cloth under the item to catch the drips. Any item to be coated should be about two inches above the work area so that the extra mixture will drip off the item.For surfaces like paper, use Mod Podge.For wood, apply two to three coats of our bartop epoxy as a seal coat, sanding lightly between coats. For best results, the substrate surface must be dry and free of dust, wax, grease, or oil.You may also add Universal Paint colorants to achieve the desired results if they are water-based and not oil-based.Ī 1.5 gallon kit contains one gallon of resin component and a half gallon of hardener component. Use multiples coats to achieve the desired thickness.įor coloring, Pigmently Epoxy Colored Pigments or Pigmently Liquid Dye can be mixed in. Note: Pouring a single layer with a thickness greater than one inch may cause excessive bubbles, yellowing, and distortion in the surface. 1 inch thick – 1.5 gallon kit – 2.5 square feet.½ inch thick - 1.5 gallon kit - 5 square feet.¼ inch thick – 1.5 gallon kit – 10 square feet.It provides a crystal clear casting of various objects, decorative jewelry, thick-poured surfaces, burl wood tables-limitless possibilities. Ultra Clear Deep Pour Epoxy is a premium, two-component, 100% solids, high-build epoxy coating used for water-clear epoxy pours from ¼ inch – 1 inch deep per layer. Download our Ultra Clear Deep Pour Epoxy instructions here ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |